McHale V Series Baler
80
Net delay
This is used to set the time delay between the bale full
alarm sounding and the net actually feeding into the
chamber. Some operators prefer a longer time delay to
ensure adequate warning when baling at higher speeds.
Net metres
This is used to reset the net metres total. Press ‘RESET’
(button 1). Press (button 3) to confirm the reset. (See
‘Net metres’)
Pre-warning beep
This is a single warning beep to indicate when the bale is
nearly full. The setting is a percentage of the selected
bale size. Set to 99% if this function is not desired.
Bale shape indicator
This is used to turn on/off the bale shape indicators and
beeps. (See ‘Bale shape indicators’)
On () = Bale shape indicators are shown on the screen
but no beeps are active.
Off () = No bale shape indicators or beeps are active.
Beep () = Bale shape indicators are shown on the
screen and the beeps are active.
Bale shape indicator zero
This is used to set the centre position of the bale shape
indicator sensor. Normally, this is only required with a
new machine or when the sensor is replaced. To set the
zero position, make sure the chamber is fully closed with
no crop in the chamber, then select the bale shape
indicator zero setting and press ‘RESET’ (button 1).
Press (button 3) to confirm the reset.
Measurement units
Depending on operator preference, either metric or
imperial units can be selected.
Knife pressure
This sets the target knife pressure and is adjustable
between 1 and 10 (32.5-55 bar). The default setting is 6
(45 bar). ‘Knife pressure too high’ warning is shown if the
knife pressure exceeds 65 bar.
Additive
This feature is used to activate/de-activate an additive
applicator. When this setting is on, the additive applicator
output is automatically controlled. It automatically turns
off to minimise additive wastage when no crop is feeding
in during netting or while the chamber is open. Turning
this setting off disables the additive output for baling
crops that do not require additive.
To Next Page
Loading...
