Medeli SP5500 - Split Point; Pedal Assign

Function Menu
Split Point
Pedal Assign
21
This function sets the pedal type to soft pedal, sostenuto
pedal, memory select pedal, start/stop pedal.
The default pedal is soft pedal.
The LCD displays the type of pedal.
This function sets the point that separate the entire
keyboard to two section.
The LCD displays the split point value.
Use [+/YES] / [-/NO] or DIAL to change the split point.
You may also use keyboard to change the split point by
simply selecting the note you desired to be the point of
separation. The part below the split point is the the
CHORD area.
FUNCTION
NEXTBACK
- / NO + / YES
FUNCTION
NEXTBACK
- / NO + / YES
FUNCTION
NEXTBACK
- / NO + / YES
FUNCTION
NEXTBACK
- / NO + / YES
Use [+/YES] / [-/NO] or DIAL to change the pedal assign.
Reverb Level
The LCD displays the reverb level.
0 to 127. The default value is floating and follows the voice.
Use [+/YES] / [-/NO] or DIAL to change the reverb level.
The level ranges from
Chorus Level
The LCD displays the chorus level. The level ranges from
0 to 127. The default value is floating and follows the voice.
Use [+/YES] / [-/NO] or DIAL to change the chorus level.
1
1
1
1
2
2
2
2
DZB63B0DQXDOB*BSGIDZB63B0DQXDOB*BSGI 