218 Version 1.0
6. Q: The WinXP wireless interface couldn’t communicate the WEP with MT4205’s
wireless interface.
A: The default WEP of WinXP is Authentication Open System - WEP, but the WEP of
MT4205 is only for Shared Key - WEP, it caused both sides couldn’t communicate.
Please select the WEP of WinXP from Authentication Open System to Pre-shared
Key - WEP, and then the WEP wireless interface between WinXP and MT4205 would
be communicated.
7.7 Samba Server
1. Q: Why can’t I access the Samba Folder via my network places while connecting
to MT4205?
A: First, you should check if you have connected assigned storage device properly.
Then enable Samba Server afterwards, so that it can be accessed.
7.8 USB FTP Server
1. Q: How does MT4205 assign numbers for the Hard Disk?
A: The USB FTP operation of MT4205 is to assign the numbers as a, b, c, d when
catch different HDs, if there are 2 or more main partitions in the same HD, then the
assign number will plus 1,2,3,4 (e.g. a1, a2, a3, a4); and the logic partition will be
assigned number from 5 (e.g. a5, a6, a7……).
Example: There are 2 hard disks, one of them has 1 main partition and 2 logic
partitions, and the other one has 2 main partitions. Both these 2 hard disks connect
to MT4205’s USB port, and the screen will show the router’s data folder as a1, a5,
a6, b1, b2 when log in FTP.
※
Notice: To authorize the right to each user who uses MT4205 FTP function,
please go to the router’s data folder to set up.
3. Q: How to Add Account under USB FTP Server?
A: To add a new Account, Username and Password are not allowed to leave with blank
space, and the password should be 1 to 8 letters. When input the words, the
character will always show hexed (6) ―*‖ form for the security scruple. For adding the
new users, please click on Add button to add the name into User Account List, and
To Next Page
Loading...