Mega 105WR - Tr-069

Mega 105WR Router - Manual
Page 35 of 82
To create a temporary user account for a remote access to your router, follow the procedure
below.
1. Select WAN Update to enable write privileges on the router for the remote user.
2. Select WAN Access to enable read privileges on the router for the remote user.
3. Enter a user name and password in the User Name and Password fields.
4. Enter a port number In the Port field (for example, 51003).
5. Click Apply to temporarily activate the settings on the page.
Note—the changes take effect when you click Apply; however, if the router configuration is not
saved, these changes will be lost upon reboot.
6. To make the change permanent, click Save Settings.
7. To access your router remotely, enter the following URL in a browser :
http(s)://WAN IP of router:Port Number
4.5.13 TR-069
WARNING : Telkom uses TR-069 to assist with product support and fault correction. If you
disable this function or modify any of the parameters, Telkom staff will NOT be able to help you
in the event you you having ADSL problems. Please do not modify any parameters under this
section unless you know EXACTLY what you are doing.
TR-069 is a CPE (Customer Premises Equipment) Management Protocol to be used on WAN
interfaces, and is intended for communication between a CPE router and an Auto-Configuration
Server (ACS). TR-069 enables the secure auto-configuration of a CPE, and also incorporates
other CPE management functions into a common framework.
The CPE WAN Management Protocol is intended to support a variety of functionalities to
manage a collection of CPE, including the following primary capabilities:
• Auto-configuration and dynamic service provisioning
• Software/firmware image management
• Status and performance monitoring
• Diagnostics
Figure 4-27 shows the default TR-069 page, which is accessed by clicking the TR-069 link on
the Advanced page. The TR-069 page allows you to set up connection parameters.