Megger MFT1815 User Manual

13. Appendix A – Sending, Storing, Deleting and Recalling Test
Results (MFT1835 and MFT1845+)
Test results can be stored in the MFT, or downloaded immediately to a Bluetooth
®
compatible device, or both.
See “11. Setup options” on page 53,
Test results are stored in “Folders” against a set of circuit references as below:
Folders:
Jb 000 to 255 Job number – Allows results from different locations to be saved in one instrument
Db 001 to 255 Distribution board number
CIR 000 to 255 Circuit reference number
PHA 001 to 003 Phase number
Circuit type:
In addition, the following circuit descriptors are used to identify on which part of the circuit the measurement was
made:
Insulation:
Symbol Definition
L – E Live to Earth Test
L – N Live to Neutral Test
N – E Neutral to Earth Test
L – L Live to Live Test
- - - No connection selected
Continuity:
Symbol Definition
R1 Live
R2 Circuit Protective Conductor
R12 R1 + R2
RR1 Ring Circuit Phase-Phase
RR2 Ring Circuit CPC-CPC
RRN Ring Circuit Neutral-Neutral
- - - No connection selected
Loop Testing:
L-E range measurements are automatically saved as L-E connections
L-N range
Symbol Definition
L – E Live to Earth Test
L – N Live to Neutral Test
L – L Live to Live Test
RCD/GFCI:
Not relevant
Earth testing:
Earth measurements are saved under a job number only
www.megger.com
MFT1800 series
56
Appendix A – Sending, Storing, Deleting and Recalling Test Results (MFT1835 and MFT1845+)

Megger MFT1815 Specifications

General

Brand	Megger
Model	MFT1815
Category	Test Equipment
Language	English