EasyManuals Logo

Mercury 50 Service Manual

Mercury 50
599 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #451 background imageLoading...
Page #451 background image
MANUAL TILT ASSIST
Page 5D-38 90-828631R3 MARCH 1999
Bleeding Manual Tilt System
IMPORTANT: While bleeding tilt system, time must be allowed between each stroke
to allow air bubbles to dissipate.
1. With shock rod in the full up position and manifold cam lever open (facing down), secure
tilt system to retaining tool and container. (A No. 10 can or 3 lb coffee can could be used.)
2. Fill container to near full level using Quicksilver Power Trim and Steering Fluid. If not
available, use automotive (ATF) automatic transmission fluid.
IMPORTANT: Fluid level must remain above accumulator opening during bleeding
process.
50447
d
e
a
b
c
a
a-Retaining Tool
b-Tilt System
c-Container
d-Cam Lever
e-Accumulator Opening
3. Bleed unit by pushing rod down slowly (18-20 seconds per stroke) until stopped at base.
Wait until all air bubbles exit accumulator base.
50432

Table of Contents

Other manuals for Mercury 50

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 50 and is the answer not in the manual?

Mercury 50 Specifications

General IconGeneral
Horsepower50 hp
Cylinders3
SteeringRemote
StartingElectric
Displacement995 cc
Fuel Induction SystemEFI (Electronic Fuel Injection)
Alternator Output18 amp
Shaft Length20" / 508 mm
Dry Weight112 kg
Engine Type4-Stroke

Related product manuals