Mercusys MR50G - Wireless; Wireless Settings

36
Chapter 5 Advanced Conguration
• Network Destination - The destination IP address that you want to assign to
a static route. This IP address cannot be on the same subnet with the WAN IP
or LAN IP of Router A. In the example, the IP address of the company network
is the destination IP address, so here enter 172.30.30.1.
• Subnet Mask - The Subnet Mask determines which portion of an IP address
is the network portion, and which portion is the host portion.
• Default Gateway - The IP address of the gateway device to which the data
packets will be sent. This IP address must be on the same subnet with the
router’s IP which sends out data. In the example, the data packets will be sent
to the LAN port of Router B and then to the Server, so the default gateway
should be 192.168.1.2.
• Interface - Determined by the port (WAN/LAN) that sends out data packets.
In the example, the data are sent to the gateway through the LAN port of
Router A, so LAN should be selected.
• Description - Enter a description for this static routing entry.
5. Click SAVE.
6. Check the Routing Table below. If you can nd the entry you’ve set, the static
routing is set successfully.
5.2 Wireless
5. 2. 1. Wireless Settings
1. Visit http://mwlogin.net, and log in with the password you set for the router.
2. Go to Advanced > Wireless > Wireless Settings.
3. Congure the wireless settings for the wireless network and click SAVE.