300Mbps Wireless N ADSL2+ Modem Router
- 28 -
• SSID Index: The index of the SSID, and in this model, you can only leave it as a default
value of 1.
• PerSSID Switch: Select Activated to allow switch of per SSID.
• Broadcast SSID: When wireless clients survey the local area for wireless networks to
associate with, they will detect the SSID broadcasted by the modem router. To
broadcast the modem router’s SSID, keep the default setting. If you don’t want to
broadcast the modem router’s SSID, select No.
• Use WPS: Use WPS (Wi-Fi Protected Setup) function, you can add a new wireless
device to an existing network quickly. To use WPS, keep the default setting, and
configure the parameters in WPS Settings. If you don’t want to Use WPS, select No.
WPS Settings: WPS can help you to add a new wireless device to an existing network quickly.
• WPS state: Display the current WPS state.
• WPS mode: If the wireless adapter supports Wi-Fi Protected Setup (WPS), you can
establish a wireless connection between wireless adapter and modem router using
either PIN method or Push Button Configuration (PBC) method, please select the one
you want.
1) PIN Code
If the wireless adapter supports Wi-Fi Protected Setup and the PIN method, you can add it
to the network by PIN with the following two methods. Select PIN code, you will see the
following screen.
Method One: Enter the PIN of wireless adapter into my modem router
Step 1: For the configuration of the wireless adapter, please choose Enter the PIN of this
device into my access point or wireless router in the configuration utility, and get
the PIN code on the screen as below, then click Connect.
To Next Page
Loading...
