300Mbps Wireless N ADSL2+ Modem Router
- 38 -
4.3.3.2 Virtual Server
Go to Advanced Setup → NAT → Virtual Server, you can configure the Virtual Server in the
following screen.
The Virtual Server is the server or server(s) behind NAT (on the LAN), for example, Web server
or FTP server, which you can make visible to the outside world even though NAT makes your
whole inside network appear as a single machine to the outside world.
• Rule Index: The Virtual server rule index for this VC. You can specify 10 rules in maximum.
All the VCs with single IP will use the same Virtual Server rules.
• Application: The Virtual servers can be used for setting up public services on your LAN.
• Protocol: The protocol used for this application.
• Start & End port number: Enter the specific Start and End Port number you want to
forward. If it is one port only, you can enter the End port number the same as Start port
number. For example, if you want to set the FTP Virtual server, you can set the start and
end port number to 21.
• Local IP Address: Enter the IP Address for the Virtual Server in LAN side.
• Virtual Server Listing: This displays the information about the Virtual Servers you
establish.
To add a virtual server entry:
Step 1: Select Virtual Circuit and select Virtual Server.
Step 2: Select the Rule index for the rule.
Step 3: Select the application you want from drop-down list, then the protocol and port
number will be added to the corresponding field automatically. You only need to
configure the IP address for the virtual server. If the application list does not contain
the service that you want, please configure the Port number, IP Address and Protocol
manually.
Step 4: After that, click SAVE to make the entry take effect.
Note:
For VCs with single IP, select Single; For VCs with multiple IPs, select Multiple for the option.
To Next Page
Loading...
Need help?
General
