300Mbps Wireless N Router User Guide
as below.
▶ MAC Address - The physical address of the router, as seen from the LAN. The value can't
be changed.
▶ LAN IP Settings - Select Auto or Manual. In Auto mode, the router will automatically detect
the LAN-WAN IP address confliction.
▶ IP Address - Enter the IP address of your router.
▶ Subnet Mask - An address code that determines the size of the network. Normally use
255.255.255.0 as the subnet mask.
5.1.3 IPv6
Go to Network→IPv6, you can configure IPv6 settings of your router.
Select a working mode according to your ISP network topology.
1)
If you change the LAN IP address, you must use the new IP address to log in to the
router.
2) If the new LAN IP address you set is not in the same s
ubnet with the previous one, the IP
Address pool in the DHCP server will be configured automatically, but the Virtual Server
- 22 -
To Next Page
Loading...
