Page 10 of 104
Menu System
When you first enter the Menu system by pressing the Enter key, you will see the
following Main Menu:
Feeder Control… ↑
Calibration…
Warnings…
Faults…
Display Settings…
Basic Setup…
Advanced Setup…
Reset Totals…
DNA Key…
Diagnostics…
Drag Chain Control… ↓
Note: Not all the of the above entries will necessarily appear in the menu, depending on
how the controller is configured (see Advanced Set-up > Configuration ).
Feeder Control
(Main Menu)
Note: The items presented in the Feeder Control menu will vary depending on the
current control method and source. Also “Feeder Control” only appears in the Main
Menu if “Feeder Control” is configured (see Main Menu > Advanced Set-up >
Configuration).
The following is a list of all Feeder Control items and their functions:
Start [Stop] Feeder… ↑
Setpoint…
Jog Forward
Jog Reverse ↓
To Next Page
Loading...
Need help?
Operating Environment
Power
