Page 68 of 104
Pre-feeder… ↑
Drive Feedback…
Material on Belt Sw…
Discharge Monitor…
Drag Chain…
Infeed Flow Monitor… ↓
Pre-feeder (not available yet)
Note, there are many pre-feeder arrangements that can be accommodated with
the standard Genetix. If you have a pre-feeder application and require assistance,
contact the Merrick Customer Support department.
Drive Feedback
Note: To enable this item, see Main Menu > Advanced Setup >Configuration >
Drive Feedback
Many feeder drives (i.e. VFD, PWM, SCR) have extra digital outputs that can help
diagnose drive related problems. By enabling the Genetix “Drive Feedback”
feature, additional GCM inputs and outputs are turned on that can be used to
improve overall feeder diagnostics by including drive diagnostics. See below for
the menu of settings and parameters and descriptions of the I/O functionality.
Settings… ↑
Numeric Data… ↓
Settings
The following settings are available for Drive Feedback:
Overld Connected ↑
AtSpd Connected ↓
Overld Connected
This is a switch (Y/N) that tells the Genetix that the drive has an overload
output and that is connected to a GCM input, which has been mapped to the
Logical input “Belt Drv Overld.
To Next Page
Loading...
