Page 85 of 104
Date & Time
(Main Menu > Advanced Setup > Date & Time)
Selecting this menu item, you will be presented with the following menu:
Hour ↑
Minute
Day
Month
Year ↓
Selection of any of the above items brings up the Numeric Data Entry screen allowing
the user to set that particular parameter. All parameters are limited appropriately.
These data are normally set at the factory, according to the local time zone.
Passwords
(Main Menu > Advanced Setup > Passwords)
Selecting this menu item, you will be presented with the following menu:
Calibration ↑
Basic Setup
Advanced Setup
Direct Param Edit ↓
Selection of any of the first three above items brings up the Numeric Data Entry
screen allowing the user to change that particular password. All passwords are 4 digit
numbers, settable from “0000” to “9999”. Setting all four digits of any password to
zero defeats that password (disables security) for those menus requiring that
password.
Note: If you select the “Direct Param Edit” password from the above list, you will be
asked to enter this password before being allowed to change it.
GCM Name
Each Genetix GCM is allowed to have a unique “friendly” name. This name will be
displayed in the top left corner of the User Interface, and may also be used in certain
communications modes (i.e. Bluetooth) to identify the feeder you wish to talk to.
The maximum number of characters for this name is 15 and may consist of any
alphabetic (upper or lower case) or numeric character, plus some special characters.
You may use this name to identify the feeder any way you wish, but the name should
be unique at your plant.
To Next Page
Loading...
