Page 97 of 104
Start [Stop] Drag Chain… ↑
Jog Forward
Jog Reverse ↓
Start [Stop] Drag Chain
If the drag chain is not linked to Feeder Running (see Main Menu > Advanced Set-up
> Feeder Peripherals > Drag Chain > Settings), or if feeder is in Manual mode, this
menu item allows you to start and stop the drag chain. If the drag chain is not
running, this item will read “Start Drag Chain”. If the drag chain has already been
started, this item will read “Stop Drag Chain”.
Note: If the drag chain has been configured to run in “timed” mode, the drag chain will
actually run in accordance with the timer settings, once started (see Main Menu >
Advanced Set-up > Feeder Peripherals > Drag Chain > Numeric Data).
Jog Forward
If the feeder is in Manual mode, this command will appear and will run the drag chain
forward as long as you hold the Enter key down.
Jog Reverse
If the feeder is in Manual mode and the drag chain has been configured as reversible,
this command will appear and will run the drag chain in reverse as long as you hold
the Enter key down.
Note: If Drag Chain is linked to Auto Run, no start/stop options will be shown (see
Main Menu > Advanced Setup > Feeder Peripherals > Drag Chain > Settings).
To Next Page
Loading...
