Page 96 of 104
If you confirm, all of the data on the present DNA Key will be written to the Genetix
GCM will be overwritten, re-configuring it. If successful, the Help message will read,
“Reading data”, and then,
“Successful Restore”
Diagnostics
(Main Menu > Diagnostics)
Selection of “Diagnostics” from the Main menu presents a list of items the use can select
to see specific data for diagnostics or informational purposes. The following sections are
available,
Load Cells… ↑
Tachos…
Analog Inputs…
Analog Outputs…
Digital Inputs…
Digital Outputs…
Misc Data…
Unit Conversions…
GCM Mem/DNA Key…
Calibration…
Communication… ↓
Each of the above menu items displays additional screens with data relative to that
particular item. Many items have multiple screens, and for those you will see “← →” in
the lower right of the display. You may scroll through the available screens with the left
and right arrow keys.
Drag Chain Control
(Main Menu > Drag Chain Control)
Note: The items presented in the Drag Chain Control menu will vary depending on
current configuration. Also “Drag Chain Control” only appears in the Main Menu if “Drag
Chain” is enabled (see Main Menu > Advanced Set-up > Configuration).
The following is a list of all Feeder Control items and their functions:
To Next Page
Loading...
