MERRICK Genetix - Feeder Control, Limits, Load Cells, Tachos

Page 29 of 104
Feeder Control… ↑
Limits…
Load Cells…
Tachos…
Process Control…
Analog I/O…
Digital I/O…
Totalizer…
Feeder Peripherals…
Communications…
Date & Time…
Passwords…
GCM Name…
Direct Param Edit…
Configuration… ↓
Note: Some of the above items may not appear, depending on the Configuration settings
(see Main Menu > Advanced Setup > Configuration)
Selection of one of the entries from the above list will present further selections in each
category as shown below
Feeder Control
(Main Menu > Advanced Setup > Feeder Control)
Note: This item will appear in the menu only if Feeder Control is enabled (see Main
Menu > Advanced Setup > Configuration > Feeder Control).
Selecting this menu item, you will be presented with the following menu: