Metasphere MM-IM - Isa.map; Df.cfg; Ipdial.cfg

MM-IM User Guide
78
OS
{
GA=4;
OA=4;
EV=84;
AL=84;
TR=84;
DP=S9;
PO=NONE;
BP=60000;
OV=0;
PD=1200;
AF=0;
TP=7200;
TT=4;
WEB=1;
}
Isa.map
Isa.map provides the mapping between Straton variable names and Medina point names.
There is one line per point that needs to be mapped to/from Straton. The “R” or “W” is a
legacy bit of information that used to indicate whether the point was to be read from or
written to Straton. All points are now mapped as both “read” and “write”, regardless of the
letter.
OSTIME AID0 R
PUM1MX AID1 R
PUM1RT AID2 R
PUM1HT AID3 R
PUM2MX AID4 R
PUM2RT AID5 R
PUM1RU DI4 W
PUM2RU DI6 W
PUM1HR PID0 R
PUM2HR PID1 R
Df.cfg
Df.cfg is used to configure the DF1 driver. It contains details of the polling blocks that
have been configured in MicroMC.
NAME=DI0;
BAUD=9600;
STATUS=AI0;
MM4=4;
NODE=1;
CH=2;
ACTION=R;
TYPE=N;
OFFSET=0;
SIZE=2;
FILE=10;
NAME=PI17;
MM4=4;
NODE=1;
CH=2;
ACTION=R;
TYPE=N;
OFFSET=0;
SIZE=1;
FILE=12;
Ipdial.cfg
Ipdial.cfg is a very small file that contains the IP addresses of the DG(s) on which the set
that the MM-IM belongs to is configured. The MM-IM uses these addresses to contact the
DG following power-up or reset.