MM-IM User Guide
58
Configuring Master Control for a MM-IM
Before using the MM-IM, you must configure Master Control with information about the
RTU so that the device is recognised and data communications will take place as required.
Creating a configuration
Configuration of any RTU on Master Control is performed by DBE, the DataBase Editor. A
separate manual “Master Control Database Editor” is provided with full details of how to
use the tool. This document is intended to show only the pertinent points relating to MM-
IM configuration.
After invoking DBE and choosing to create an outstation configuration, you will be
presented with the following screens, one showing general information and the other
showing details of the communications.
To Next Page
Loading...