Controller / User Interface | 4-13
3. From the Serial Port Configuration dialog box, verify the Address en-
tered in the Device Communication tab matches the Address in this
dialog box.
Click RS-485 Port to enable the Remote Service Port. Click OK to save
this change.
Check the Status message (General tab) again. It should now read
“Online” if the communication settings for the analyzer and PC are
correct.
4. If the error message “Communication Failure. Do you want to start
auto-detect?” appears click No then repeat Steps 2–3 and ensure the
proper settings are made.
NOTE
General (tab)Setup
To Next Page
