Metek 933 - Chapter 3 Installation and Start-Up

Installation and Start-Up | 3-1
INSTALLATION and START-UP
This chapter describes how to install and start up the Model 933 Analyzer,
including:
• Safety requirements to consider before working on the analyzer.
• Uncrating, inspecting, and storing the analyzer prior to installation.
• Installing the mechanical components and making the electrical con-
nections.
• Installing the System 200 Configurator Software on a computer, pow-
ering up the analyzer, establishing communication with the analyzer,
and performing start-up checks and adjustments.
• Performing a sample system leak check.
The installation of the analyzer must be in accordance with all of the
end user and local regulatory standards and procedures. There are no
operator-serviceable components inside the analyzer. Refer servicing
to qualified personnel.
!
WARNING