Installation and Start-Up | 3-45
To change the Hold Time:
1. From the Output Setup dialog box (Figure 3-16), click Alarm Disable.
Click OK.
2. View the Column Timing dialog box (Figure 3-21) and enter the new
Hold Time for the species of interest. Click OK then Apply. Save the
change to EEPROM.
3. After the Switch Interval and Hold Time settings have been set,
return to the Output Setup dialog box, click Alarm Enable, and then
click OK.
The Hold Time for species not mentioned should be set to that of H
2
S.
NOTE
Setup (tab)Output
Setup (tab)
Column Timing
To Next Page
Loading...
