￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Installation
￭￭￭￭￭￭￭￭
13
4 Installation
4.1 Unpacking and inspecting the instrument
4.1.1 Packaging
The product and accessories are supplied in protective special packaging.
Keep this packaging to ensure safe transportation of the product. If a
transport lock is present, keep this as well for future reuse.
4.1.2 Checks
Inspect the delivery immediately upon receipt:
￭ Check the delivery against the delivery note to ensure completeness.
￭ Check the product for damage.
￭ If the delivery is incomplete or damaged, contact your regional
Metrohm representative.
4.1.3 Application area
The 949 pH Meter has been developed for use in a laboratory.
CAUTION
Influence of weather conditions
Damage to devices as a result of direct sunlight or temperatures below
freezing.
When you are not using the device, do not expose it to direct sunlight
or to temperatures below 0 °C.
4.1.4 Setup location
Place the device on a flat, stable laboratory bench that is easily accessible
from the front and the side. Metrohm recommends setting the device up
at least 20 cm away from any parts above it or in its vicinity.
With this positioning of the device, there is no longer any residual risk of
damage caused by manual handling of loads.
Ensure that the device and its surroundings are properly illuminated.
To Next Page
Loading...
