￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Operation
￭￭￭￭￭￭￭￭
39
￭ The symbol flashes on the display. The flashing symbol
shows that saving is in progress.
5
Exiting the data collection
Press the button to exit the data collection.
NOTE
If automatic data collection is set, but not in operation, then the
symbol will remain on the display.
NOTE
￭ As soon as the measuring parameter is changed, automatic data col-
lection ends.
￭ Data collection ends automatically as soon as the total capacity of
1,000 data points is reached.
5.7.4 Manual data collection
Example: Save a pH value manually.
1
Opening the settings
￭ Use the button to change to the range.
￭ Press the button to access the settings.
￭ Open the P8.0 memory settings.
Confirm the selection with the
button.
￭ Use the and buttons to select the P8.1 memory setting.
￭ Confirm the selection with the
button.
2
Setting Manual data collection
￭ Use the and buttons to select MANUAL.
￭ Confirm the selection with the button.
￭ Press the
button twice to return to measuring mode.
To Next Page
Loading...
