If you are not seeing any options on the list within the Remote Cam tabs, please check the following:
• - Make sure the remote system is on the same network, connected to the same Router or Access
Point as your Studio system.
• - If the system is on the same network but using a different access point, the Remote Camera
will not properly connect.
• - Check that the following ports are open if you use a firewall:
• - UDP: 5353, 60936 - 61036
- TCP: 60936 - 61036
• - Check that Bonjour Service is started.
• - If you've checked all the above steps and you are connecting over Ethernet, there could be a rare IP
configuration issue.
•
Mevo Start User Manual
Page 119
To Next Page
Loading...