Turn the Mevo Start Camera On and Off
When your Mevo Start is plugged in or fully charged, you can power it on.
To do so, simply press and hold the power button at the back of the camera for a moment. The
battery light will flash on for a moment and you will hear a pair of short beeps.
At this point, you can remove your finger from the power button. The LEDs will blink as the camera
starts up.
When the LED lights are stable, the camera is ready to be used.
When you are finished using your Mevo Start, simply press and hold the power button until all the
LEDs are lit up and you hear a couple beeps. The camera will turn off..
Mevo Start User Manual
Page 31
To Next Page
Loading...