MG 47 Series - Page 43

4347LHZ EM-9517-B Rev.10
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
7
■ TO GO ON TO SET THE DISPLAY SCALING VALUE B,
Skip to Step 3 in “4.4 STEP 4. DISPLAY SCALING VALUE B”.
■ TO QUIT,
Hold down Alarm/↓ or Scale/↑ button for 1 second or more to return to Measuring Mode.
NOTE
■ INPUT SCALING SETTING
• Do not set ‘input scaling value A ≥ input scaling value B’.
■ IF THE FRONT BUTTONS ARE LEFT UNTOUCHED…
• The indication turns on with applying the last changes after the specied time period (default: 15 sec.) while it is in the
setting standby mode (indication blinking in Step 4 and 5).
• The display goes back automatically to Measuring Mode after the specied time period (default: 15 sec.) in one of the
other modes.
• This time period (automatic return time) is congurable. (Refer to 10. GOING BACK AUTOMATICALLY TO MEASUR-
ING MODE.)
■ TO ABORT A SETTING…
• Hold down Max/Min button for 1 second or more in the setting standby mode (indication blinking in Step 4 and 5) to
return to Measuring Mode without applying the last changes.
• If you get lost in a setting mode, you can execute initialization. (Refer to 16.2 INITIALIZING SETTING VALUES.)
■ SHIFTING DIGITS
• Each time pressing Shift button, the blinking digit moves to the right.
■ SETTING A NUMERICAL VALUE
• Each time pressing Up button, the numeral is incremented by 1.
・・・・・