Seite 111
Appendix | Smart Averaging
thermoMETER CTL
A 5 Smart Averaging
The average function is generally used to smoothen the output signal. With the adjustable parameter time this function can be optimal
adjusted to the respective application. One disadvantage of the average function is that fast temperature peaks which are caused by
dynamic events are subjected to the same averaging time. Therefore those peaks can only be seen with a delay on the signal output.
The function Smart Averaging eliminates this disadvantage by passing those fast events without averaging directly through to the
signal output.
Fig. 37 Signal graph with Smart Averaging function Fig. 38 Signal graph without Smart Averaging function
To Next Page
Loading...