MICRO-EPSILON thermoMETER CTL Series - Power Supply

112 pages

Save Page as PDF

To Next Page

To Previous Page

Page 44

Electrical Installation

thermoMETER CTL

7.2 Power Supply

Please use a power supply unit with an output voltage of 8 - 36 VDC that provides at least 160 mA cur-

rent. Residual ripple should be no more than 200 mV.

Never apply voltage to the analog outputs.

> Destruction of the output

The CTL is not a 2-wire sensor.

Main Page

Default Chapter3
- Table of Contents3
1 Safety7
- Symbols Used7
- Warnings7
- Notes on CE Marking8
- Intended Use9
- Proper Environment9
2 Laser Safety10
3 Technical Data12
- Functional Principle12
- Sensor Models13
- General Specifications14
- Electrical Specifications15
- Measurement Specifications16
4 Delivery22
- Unpacking, Included in Delivery22
- Storage22
5 Optical Charts23
6 Mechanical Installation37
- Sensor37
- Controller38
- Mounting Bracket39
7 Electrical Installation40
- Cable Connections40
  - Basic Version40
  - Connector Version40
- Power Supply44
- Cable Assembling45
- Ground Connection46
  - CTLM-5, CTLM-1, CTLM-2, CTLM-3L, CTLM-3H, CTLM-3H1 to -3H3 Models46
  - CTL, CTLF, CTLC-4, CTLC-2, CTLC-6, CTLG Models47
- Exchange of the Sensor48
  - Entering of the Calibration Code49
  - Exchange of the Sensor Cable50
8 Outputs and Inputs51
- Analog Outputs51
  - Output Channel 151
  - Output Channel 2 [Only for CTL, CTLG]51
- Digital Interfaces52
- Relays Outputs78
- Functional Inputs79
- Alarms80
9 Operation82
- Sensor Settings82
- Explanation to the Menu Items85
- Digital Command Set87
- Laser Sighting88
- Error Messages89
  - CTL, CTLF, CTLC-4, CTLC-2, CTLC-6, CTLG Models89
  - CTLM-5, CTLM-1, CTLM-2, CTLM-3L, CTLM-3H, CTLM-3H1 bis -3H3 Models89
10 Instructions for Operation90
- Cleaning90
11 Compactconnect Software91
- System Requirements91
- Main Features91
12 Communication Settings92
- Serial Interface92
- Protocol92
- ASCII Protocol92
- Saving of Parameter Settings93
13 Basics of Infrared Thermometry94
14 Emissivity95
- Definition95
- Determination of Unknown Emissivity95
- Characteristic Emissivity96
15 Liability for Material Defects97
16 Service, Repair98
17 Decommissioning, Disposal98
Appendix99
A 1 Optional Accessories99
- A 1.1 Air Purge Collar99
- A 1.2 Mounting Bracket100
- A 1.3 Water Cooled Housing101
- A 1.4 High Temperature Cable102
- A 1.5 Rail Mount Adapter for Controller102
A 2 Factory Settings103
Emissivity Table Metals106
A 4 Emissivity Table Non Metals109
A 5 Smart Averaging111

MICRO-EPSILON thermoMETER CTL Series - Power Supply

Table of Contents