Microhard Systems pX2 - Page 104

© Microhard Systems Inc. 104
5.0 AT Command Line Interface
AT+MNWAN
Command Syntax (Effect: AT&W)
Show/Add/Edit/Delete the WAN interface.
AT+MNWAN=<Mode>[,<Protocol>[,<Route>][,<IP>,<Netmask>[,<Gateway>]]]
Usage:
AT+MNWAN
AT+MNWAN=<Mode>,<Protocol>,<Route>,<IP>,<Netmask>[,<Gateway>]
Where <Mode>=0 and <Protocol>=0
AT+MNWAN=<Mode>,<Protocol>,<Route>
Where <Mode>=0 and <Protocol>=1
AT+MNWAN=<Mode>
Where <Mode>=1
AT+MNWAN=<Mode>,<Protocol>,<IP>,<Netmask>[,<Gateway>]
Where <Mode>=2 and <Protocol>=0
AT+MNWAN=<Mode>,<Protocol>
Where <Mode>=2 and <Protocol>=1
Parameters:
Mode: 0 - Independent WAN
1 - Bridge with LAN Port
2 - Independent LAN
Protocol: 0 - Static IP
1 - DHCP
IP: Valid IP address
Netmask: Valid netmask
Gateway: Valid IP address. 0 - Reset
Route: Default Route
0 - No
1 - Yes
Description
Example
Input:
AT+MNWAN?
Response:
Working Mode : Independent WAN
WAN Configuration
Connection Type : Static IP
IP Address : 10.10.10.254
Netmask : 10.10.10.10.1
Default Gateway: 255.255.255.252
DefaultRoute : No
DNS Server
Mode : manual
Primary DNS :
Secondary DNS :
OK