Microhard Systems pX2 - Page 105

© Microhard Systems Inc. 105
5.0 AT Command Line Interface
AT+MNWANLANDHCP
Command Syntax (Effect: AT&W)
Get/Set LAN DHCP when WAN set to Independent LAN
AT+MNWANLANDHCP=[<Mode>[,<Start IP>,<Limit>,<Lease Time>[,<Alt.Gateway>,<Pre.DN
S>,<Alt.DNS>]]]
Usage:
AT+MNWANLANDHCP
AT+MNWANLANDHCP=<Mode>
Where <Mode>=0
AT+MNWANLANDHCP=<Mode>,<Start IP>,<Limit>,<Lease Time>[,<Alt.Gateway>,<Pre.DNS>
,<Alt.DNS>] Where <Mode>=1
Parameters:
Mode : 0 - Disable DHCP Server
1 - Enable DHCP Server
Start IP : The starting address DHCP assignable IP Addresses
Limit : The maximum number of IP addresses. min=0 max=16777214
Lease Time : The DHCP lease time in minutes. min=0 max=214748364
Alt. Gateway : Alternate Gateway for DHCP assigned devices if the default gatew
ay is not to be used
Pre. DNS : Preferred DNS server address to be assigned to DHCP devices
Alt. DNS : Alternate DNS server address to be assigned to DHCP devices
Description
Example
Input:
AT+MNWANLANDHCP?
Response:
Mode : 1 - DHCP Server enabled
Start IP :
Limit :
Lease Time :
Alt. Gateway :
Pre. DNS :
Alt. DNS :
OK
AT+MNWANDNS
Command Syntax (Effect: AT&W)
Get/Set DNS Server when WAN set to independent
WAN.
AT+MNWANDNS=[<Mode>[,<Primary
DNS>,<Secondary DNS>]]
Parameters:
Mode : 0 - Auto
1 - Manual
Primary DNS : Valid IP Address
Secondary DNS : Valid IP address
Description