Microhard Systems pX2 - Page 110

© Microhard Systems Inc. 110
5.0 AT Command Line Interface
AT+MCNCDI2
Command Syntax (Effect: AT&W)
Enable/Disable Serial port no-connection data
intake.
AT+MCNCDI2=<Mode>
Mode:
0 Disable
1 Enable
Description
Example
Input:
AT+MCNCDI2=1<enter>
Response:
OK
AT+MCMTC2
Command Syntax (Effect: AT&W)
Get/Set Serial port modbus TCP configuration.
AT+MCMTC2=<Status>, <Protection status>,
<Protection Key>
Status and Protection Status:
0 Disable
1 Enable
Description
Example
Input:
AT+MCMTC2=0,0,1234<enter>
Response:
OK
AT+MCIPM2
Command Syntax (Effect: AT&W)
Set the Serial port IP Protocol Mode.
AT+MCIPM2=<Mode>
Mode:
0 TCP Client
1 TCP Server
2 TCP Client/Server
3 UDP Point to Point
8 PPP
Description
Example
Input:
AT+MCIPM2=1<enter>
Response:
OK