Microhard Systems pX2 - Page 125

© Microhard Systems Inc. 125
5.0 AT Command Line Interface
AT+MWDEVICEMODE
Command Syntax (Effect: AT&W)
Get/Set radio virtual interface: Mode
AT+MWDEVICEMODE=[<Index>[,<Device
Mode>]]
Index:
Radio Virtual Interface Index: 0-3
Device Mode:
Radio Virtual Interface Mode:
0 - Access Point
1 - Client
2 - Repeater
Description
Example
Input:
AT+MWDEVICEMODE=0,0 <enter>
Response:
OK
AT+MWRATE
Command Syntax (Effect: AT&W)
Get/Set radio virtual interface: TX bit rate
AT+MWRATE=[<Index>[,<TX bitrate>]]
Index:
Radio Virtual Interface Index: 0-3
TX bitrate:
Radio Virtual Interface TX bitrate:
0 - auto
1 - mcs-0
2 - mcs-1
3 - mcs-2
4 - mcs-3
5 - mcs-4
6 - mcs-5
7 - mcs-6
8 - mcs-7
9 - mcs-8
10 - mcs-9
11 - mcs-10
12 - mcs-11
13 - mcs-12
14 - mcs-13
15 - mcs-14
16 - mcs-15
Description
Example
Input:
AT+MWTXRATE=0,0 <enter>
Response:
OK