Micromeritics TriStar II 3020 - 1. GENERAL INFORMATION

Seat number is used by the application to create a separate log file for each computer. Click
Next.
9. In the Step 1 group box on the Analyzer Configuration window, select the number of analyzers
to be attached to this computer.
If...
Then...
installing the analysis program dur-
ing initial installation
Select the number of analyzers to be installed
using the analysis program for off-
line data reduction
Select 0
moving an analyzer from another
computer to this computer
Select 0.Refer to the section on moving a analyzer
in the Administrator's Utility for TriStar II3020 Con-
firm User Guide.
10. In the Step 2 group box on the Analyzer Configuration window, enter the serial number of
each analyzer to be attached to this computer. Click Next.
11. On the Ethernet Ports window, select one option from the following table:
3 Application Installation
TriStar II 3020 Confirm Installation Instructions and Checklist
302-42870-04 (Rev A) — Sep 2017
3 - 3