Configuring SNMP
Receiver Mode: Dynamic.
The GPS receiver surveys continuously to determine its
position and doesn't switch to another mode. This mode
must be initiated by a user, and is appropriate for mobile
applications such as ships, land vehicles, and aircraft.
The degree of accuracy this mode offers is fine for NTP
time over networks, but is less than optimal for the IRIG-B,
1PPS, 10MHz outputs available on some SyncServer models.
Receiver Mode: Hold.
The GPS receiver has completed Survey mode and switched to
this mode, or the user has manually entered a position and
forced it into this mode. The accuracy and stability of the
SyncServer's timing outputs are optimal when the receiver
has its exact position and is in this mode.
======================================================"
::= {gps 5}
etcVersion OBJECT-TYPE
SYNTAX DisplayString (SIZE(1..80))
MAX-ACCESSread-only
STATUScurrent
DESCRIPTION
"Version info for SyncServer system."
::= {etc 1}
etcSerialNbr OBJECT-TYPE
SYNTAXDisplayString (SIZE(1..40))
MAX-ACCESSread-only
STATUScurrent
DESCRIPTION
"Unique serial number factory programmed into each unit."
::= {etc 2}
etcModel OBJECT-TYPE
SYNTAXDisplayString (SIZE(1..40))
MAX-ACCESSread-only
STATUScurrent
DESCRIPTION
"Model type factory programmed into each unit."
::= {etc 3}
etcUpgrade OBJECT-TYPE
SYNTAXDisplayString (SIZE(1..1024))
MAX-ACCESSread-only
STATUScurrent
DESCRIPTION
"Describes whether or not an upgrade is available from
997-01520-02 Rev. F1.......................................................................... Page 193
To Next Page
Loading...
