Microtest 6363 - Page 33

32
 OPEN: Enter the open circuit calibration menu.
 DC: Start direct current open circuit calibration.
 Spot: Start the open circuit calibration for the current “alternating current” setting
configuration.
 All Freq: Start open circuit calibration for all frequencies.
 SHORT: Enter the short circuit calibration menu.
 DC: Start direct current short circuit calibration.
 Spot: Start the short circuit calibration for the current “alternating current” setting
configuration.
 All Freq: Start short circuit calibration for all frequencies.
※ It is recommended to perform OPEN/SHORT calibration once before performing
measurement for the first time or after changing the measurement fixture/cramp.