Midland SPD-6 - Control Module Replacement

www.roadwidener.com
282
Model SPD-6
2. Test the motor for proper operation.
Replacing actuator
P108828
B0050
B0010
Control module replacement
Removal
1. Remove four cap screws (C0110 and/or C0120). Refer to table for wrench sizes.
2. Remove control (C0010) from motor. Remove and discard gasket (C0130).
3. Proportional control only - using a magnet, remove spring seat (F0030) and spring (F0040).
Inspection
Clean and inspect the machined surfaces on the control and the endcap. If you find any nicks or
scratches, replace control or endcap. Inspect valve spool, washer, and spring. Replace if necessary.
Assembly
1. Lubricate and install spring (F0040) and spring seat (F0030) into servo.
2. Install a new gasket (C0130). Position control on motor.
Service Manual H1B 060/080/110/160/250 Bent Axis Motors
Minor repair
46 11024924 • Rev CB • February 2015