www.roadwidener.com
292
Model SPD-6
P0043
P0050
P0030
P0010
P0020
P106 524E
10 mm
115 N•m [85 lbf•ft]
see table
P0040
P0044
P0041
Seal ring
(P0044)
O-ring
(P0043)
Piston
P0050 wrench size and torque
Model Wrench size Torque
110 10 mm 115 N•m [85 lbf•ft]
060/080 8 mm 66 N•m [49 lbf•ft]
160/250 12 mm 213 Nm [157 lbf•ft]
Inspection
Clean and inspect bushings and machined surfaces for wear or damage. If wear or damage are found,
replace component in question.
Assembly
1. Lubricate and install new O-ring (P0043) and seal ring (P0044) on piston (P0041).
Allow seals time to relax before installing piston.
2. Install piston and install screw (P0050). Torque screw (P0050) per table.
3. Lubricate and install new O-ring (P0030) and install servo piston cover (P0010).
4. Using a 8 mm or 10 mm internal hex install screws (P0020). Torque to 115 N•m [85 lbf•ft].
Replace speed sensor
Removal
1. Using a 5 mm internal hex wrench, remove screw (J0020).
Service Manual H1B 060/080/110/160/250 Bent Axis Motors
Minor repair
56 11024924 • Rev CB • February 2015
To Next Page
Loading...