Midland SPD-6 - Electric Proportional Control Module

283
www.roadwidener.com
Model SPD-6
3. Install four cap screws (C0110 and/or C0120). Torque (C0110) to 37 N•m [27 lbf•ft] for proportional
control. Torque (C0110) and (C0120) to 115 Nm [85 lbf•ft] for 2 position control.
Control module removal/installation
C0010
Proportional
control
C0110 (4X)
P106 520E
F0030
F0040
C0130
6 mm
C0110 (2X)
C0010
2 position
control
C0120 (2X)
10 mm
C0130
Electric proportional control
Two position control
10 mm
115 Nm [85 lbf•ft]
37 Nm
[27 lbf•ft]
115 Nm
[85 lbf•ft]
Hydraulic proportional control
C0110 (4X)
6 mm
37 Nm
[27 lbf•ft]
C0010
Proportional
control
F0030
F0040
C0130
C0110 and C0120 Wrench Size
Control Screw Internal
Hex
Wrench
Electric and Hydraulic proportional C0110 6 mm
Two-position C0110
C0120
10 mm
10 mm
Electric proportional control module
Coil O-rings are not included in the overhaul seal kit. They may be purchased as a separate kit.
Disassembly
1. Remove the plastic cap (B0040) and O-ring (B0029). Discard the O-ring.
2. Remove the solenoid nut (B0027) using a 26mm 12-point socket. Remove and discard the O-ring
(B0028).
3. Remove the coil (B0020A). Remove and discard the O-ring (B0025).
4. Use a 4 mm internal hex wrench to remove screws (B0050). Remove solenoid (B0010).
5. Remove and discard O-ring (B0035A).
Service Manual H1B 060/080/110/160/250 Bent Axis Motors
Minor repair
11024924 • Rev CB • February 2015 47