Midland SPD-6 - Loading for Transport

www.roadwidener.com
32
Model SPD-6
5.7 loAdInG for trAnsport
1. Remove edger braces and fold edger assemblies
against blades.
2. Remove left and right push tube assemblies.
3. Position right and left side blade assemblies (A)
parallel to length of machine.
4. Attach chassis blade constraint assemblies (B) to
blades.
5. Store push tubes and outer edger brace in storage
area (C) and tie them to oor with cable ties.
6. Make sure that side access doors (D) on both sides
are secured tight.
B
A
C
D
7. Setup ramps in-line with front tires.
^ CAUTION
Front and rear wheel tracks are not the
same.
Use ramps with a minimum 15'' width or
shift ramps in, to line up with rear wheels,
after front wheels are on trailer.
1. Perform Startup Procedure. See section 5.2.
2. Pull E-stop button all the way up to release parking
brake.
3. Slowly drive forward on ramps by pushing travel
controller forward gently.
NOTICE
Prevent machine damage.
When front tires are on ramps check for
front end clearance. If hopper hits ramp,
longer, shallower ramps may be needed.
4. Drive slowly forward until front tires are on trailer.
5. Return travel controller to center (neutral) position
and apply parking brakes by pushing E-stop button
all the way down.
6. Move ramps in to line up with rear tires, release
parking brakes.
7. Drive forward until rear tires are on trailer.
8. Center machine on trailer so that tires are fully on
trailer deck.
9. Chain down from D-rings (F) on bottom of back
bumper and on both sides (E). All D-rings are
painted red.
E
E
F
F