Warning and Safety instructions
10
The dishwasher may only be operated if the door opening
mechanism is working correctly. Otherwise, there could be a risk of
danger while the automatic door opening mechanism is active.
To check that the door opening mechanism is working correctly:
- The door springs must be evenly adjusted on both sides. They are
correctly adjusted when the door remains stationary when left half
open (approx. 45° opening angle). The door must not fall open on
its own beyond this point.
- The door locking pin retracts automatically after the drying phase
when the door is opened.
Multi-socket adapters and extension leads do not guarantee the
required safety of the appliance (e.g. danger of overheating). Do not
connect the dishwasher to the electricity supply using a multi-socket
adapter or an extension cord.
The dishwasher must not be installed and operated in mobile
locations (e.g. on a ship).
Do not install the dishwasher in a room where there is a risk of
frost. Frozen hoses can break or burst. The reliability of the electronic
control unit may be impaired at temperatures below freezing point.
To avoid any damage to the dishwasher, it must only be operated
when it is connected to a fully vented plumbing system.
The plastic housing of the water connection contains an electrical
valve. The housing must not be dipped in water.
There are live wires in the water inlet hose. Do not cut the hose,
even if it is too long.
The integrated Miele Waterproof system offers protection from
water damage, provided that the following conditions are met:
- Installation has been carried out correctly.
- The dishwasher is properly maintained and parts are replaced
where it can be seen that this is necessary.
- The tap is turned off during longer absences from the home (e.g.
whilst on holiday).
The Waterproof system will work even when the dishwasher is
switched off. However, the dishwasher must remain connected to the
electricity supply.
The water connection pressure needs to be between 50 and
1000kPa.
To Next Page
