Using for the first time
30
Replenishing salt
When Refill salt appears in the
display, wait until the end of the
programme and then refill the salt
reservoir.
Confirm with OK.
The salt refill indicator will go out.
Risk of corrosion due to saline
solution.
Saline solution that runs out can
cause corrosion in the wash cabinet
and to the dishwasher load.
Immediately after filling the salt
container and each time you remove
the salt container cap, run the Rinse
saltprogramme without load items in
the dishwasher to dissolve and
remove any traces of salt from the
wash cabinet.
After the salt reservoir has been filled,
the salt refill indicator may still appear in
the display if the salt concentration has
not yet reached the correct level. In this
case, confirm the message again with
OK.
The salt refill indicator is deactivated if
the dishwasher is set to a water
hardness below 0.9mmol/l (5°dH -
German scale).
To Next Page
Loading...
