Miele G 7604 - Filling the Salt Reservoir

Using for the first time
29
Filling the salt reservoir
Before filling the salt container for the
first time, you must fill it with approx.
1.5l of water to enable the salt to
dissolve.
Once the dishwasher has been used,
there is always sufficient water in the
salt reservoir.
 Remove the lower basket from the
wash cabinet and unscrew the salt
container cap.
 Risk of corrosion due to saline
solution.
Water or saline solution will run out
of the reservoir when the cap is
opened. Saline solution that runs out
can cause corrosion in the wash
cabinet and to the dishwasher load.
The salt reservoir should therefore
only be opened to replenish the salt.
 Fill the salt reservoir with approx.
1.5litres of water (first use only).
 Place the funnel provided over the
salt container and carefully fill with
dishwasher salt until the container is
full. The salt reservoir holds up to 2kg
of salt, depending on the type of salt
used.
 Clean off salt residues from around
the salt reservoir opening. Next,
screw the salt reservoir cap on again
firmly.
 Immediately after filling the salt
container and each time you remove
the salt container cap, run the Rinse
saltprogramme without load items in
the dishwasher to dissolve and
remove any traces of salt from the
wash cabinet.