Installation
*INSTALLATION*
121
The Miele Waterproof system
Provided that your dishwasher has been
installed correctly, the Miele Waterproof
system will protect you from water
damage throughout its lifetime.
Water inlet
Danger to health due to wash
water.
Water in the dishwasher must not be
used as drinking water.
Do not drink any water from the
dishwasher.
Health risk and risk of damage
due to contaminated incoming water.
The quality of the water used must
correspond to the drinking water
specification of the country in which
the dishwasher is being operated.
Connect the dishwasher to a drinking
water supply.
The dishwasher may be connected to
cold or hot water (up to max. 60°C).
If energy-saving water-heating sources,
such as a solar water heating system,
are used, we recommend connecting to
the hot water supply. This saves both
time and electricity costs. Hot water is
used in all programmes.
The SolarSaveprogramme (if available)
requires a hot water connection of
between a minimum of 45°C and a
maximum of 60°C (intake
temperature).
The higher the water intake
temperature, the better the cleaning and
drying results.
The water inlet hose is approximately
1.5m long.
A tap with a ¾" male thread must be
provided on site. If this type of tap is not
available, only a qualified plumber may
connect the dishwasher to the
household water supply.
The dishwasher must be connected to a
mains water supply in accordance with
current local and national safety
regulations.
The water connection pressure needs to
be between 50 and 1000kPa. If the
water pressure is too high, a pressure
reducing valve must be fitted.
To Next Page
