Miele G 7604 - Fault with the Autodos (Automatic Dispensing)

Problem solving guide
110
Fault with the AutoDos (automatic dispensing)
Problem Possible cause and remedy
The following message
appears in the display:
Check PowerDisk
The AutoDos function is activated. There is no
PowerDisk or an empty PowerDisk has been inserted.
 Confirm the message Check PowerDisk with OK.
 Insert a full PowerDisk.
 Use the sensors to select the Available message
and confirm with OK (see “Detergent – Automatic
dispensing/AutoDos”).
 If you do not wish to use automatic dispensing,
deactivate the function using the AutoDos sensor
or by confirming the Not available message with OK.
The alarm tone is
sounding.
The programme does
not start or a programme
that has already started
stops.
The following message
appears in the display:
AutoDos lid open
The AutoDos lid has not been closed properly.
 Close the AutoDos lid and lock it fully (see
“Detergents - Automatic dispensing/AutoDos”).
 If the lid cannot be fully closed, check whether the
PowerDisk holder is lying flat (see “Detergents -
Inserting a PowerDisk”).
 If the same fault message appears again, call Miele.
The following message
appears in the display:
PowerDisk empty.
Deactivate AutoDos with
OK.
The AutoDosfunction is active and the PowerDisk
is empty.
 Replace the PowerDisk (see “Detergents -
Automatic dispensing/AutoDos”).
If you do not wish to use automatic dispensing,
deactivate the function using OK or the
AutoDossensor.