Miele G 7604 - General Problems with the Dishwasher; Spray Arm Fault

Problem solving guide
112
Spray arm fault
Problem Possible cause and remedy
During the programme
and at the end of the
programme, the display
shows the following
message:
Check spray arms
The dishwasher does
not switch off at the end
of the programme.
The crockery may not be
clean because no
detergent was
dispensed.
The lower spray arm is blocked or the jets of the lower
spray arm are clogged. The AutoDos detergent outlet
may not be completely flushed out.
 Switch the dishwasher off and back on again.
A message will appear in the display.
 Perform a rotation check of the lower spray arm and
rearrange the crockery if it is blocking the spray arm.
 Clean the lower spray arm (see “Cleaning and care –
Cleaning the spray arms”).
 Confirm the message withOK.
 Start the programme again.
General problems with the dishwasher
Problem Possible cause and remedy
The indicator lights and
the display are dark.
The dishwasher has switched off automatically to save
energy.
 Switch the dishwasher back on using the sensor.
Detergent residue is left
in the detergent
compartment at the end
of a programme.
The detergent compartment was still damp when
detergent was added.
 Only add the detergent when the detergent
compartment is dry.
The detergent
compartment lid cannot
be closed.
Residual detergent is blocking the catch.
 Remove the residual detergent.
At the end of a
programme there is a
film of moisture on the
inside of the door and
possibly on the interior
walls.
This is part of the normal function of the drying
system. The moisture will dissipate after a short
while.