Settings
45
AutoOpen
In some programmes the door
automatically opens slightly to assist
the drying process.
This function can be deactivated if you
wish. However, this negatively affects
the drying process in most cases.
Risk of injury due to door opening
automatically.
The door may open automatically at
the end of a programme.
Keep the area around the door free of
obstructions.
Risk of damage due to steam.
Steam from the dishwasher could
damage delicate housing units and
the edges of worktops when you
open the door at the end of the
programme if the fan is no longer
running.
If you have deactivated the automatic
door opening function but would still
like to open the door at the end of the
programme, make sure that you open
the door fully.
2nd interim rinse
You can choose this function to increase
the cleaning performance of the
programmes with a second interim
rinse.
When this function is activated, water
consumption may increase.
If this function is switched on, it will be
applied to all programmes until it is
switched off again.
Hygiene cycle
If you mainly use low temperature
programmes (<50°C), there is a risk of
bacteria and unpleasant odours building
up in the wash cabinet (see “Cleaning
and care – Hygiene cycle”).
If this function is switched on, a
message will be displayed
recommending the use of a high
temperature programme after several
low temperature programmes have
been run.
To Next Page
Loading...
