Miele G 7604 - Operation; Switching on the Dishwasher; Selecting a Programme

Operation
76
Switching on the dishwasher
 Turn on the tap if it is turned off.
 Make sure the spray arms can rotate
freely.
 Close the door.
 Touch the sensor.
If the dishwasher has been switched
off for longer than 1minute, you will
need to touch the sensor for
slightly longer (wipe protection).
The most recently started programme
will appear in the display and the
corresponding sensor will be
illuminated. If necessary, change the
programme.
Next, the estimated energy and water
consumption may be shown for the
selected programme for several
seconds.
Then the display will show the
estimated duration for the selected
programme.
The Startsensor flashes.
Selecting a programme
Choose your programme according to
the type of crockery and the degree of
soiling.
The different programmes and their
uses are described in the Programme
chart later on in this booklet.
 Touch the sensor for the required
programme.
The sensor for the selected programme
will light up.
Further programmes can be selected
under .
 To do so, touch the sensor.
The first of the further programmes will
appear in the display.
 Use the sensors in the display to
select the programme you want.
You can now select the Extras (see
“Extras”).
If any Extras are selected, the
appropriate sensors will also light up.