Miele G 7604 - Noises

Problem solving guide
113
Problem Possible cause and remedy
Water remains in the
wash cabinet at the end
of a programme.
Before rectifying the problem, you must:
 Switch the dishwasher off.
The filter combination in the wash cabinet is clogged.
 Clean the filter combination (see “Cleaning and care
– Cleaning the filters”).
The drain pump is blocked.
 Clean the drain pump (see “Cleaning and care –
Cleaning the drain pump”).
The drain hose is kinked.
 Remove any kinks from the drain hose.
Build-up of odours in the
wash cabinet.
The frequent use of low-temperature wash
programmes (<50°C) increases the risk of
contamination and odours inside the wash cabinet.
 Regularly run a high-temperature programme. This is
to prevent the build-up of residues and odours.
Noises
Problem Possible cause and remedy
Knocking noise in the
wash cabinet.
A spray arm is knocking against a crockery piece.
 Carefully open the door and rearrange the wash
items that are obstructing the spray arm.
Rattling noise in the
wash cabinet.
Items of crockery are not secure in the wash cabinet.
 Carefully open the door and rearrange the wash
items so that they sit securely.
There is a foreign object (e.g. glass shard) in the drain
pump.
 Remove the foreign object from the drain pump (see
“Cleaning and care - Cleaning the drain pump”).
Knocking noise in the
water pipes.
This may be caused by the on-site installation or the
cross-section of the piping.
 However, this will not affect the functioning of the
dishwasher in any way. If in doubt, contact a suitably
qualified plumber.