Miele G 7604 - Activating Autodos

Using for the first time
27
Activating AutoDos
The display changes to the settings
screen for AutoDos (see “Detergents -
Automatic dispensing/AutoDos”).
Even if you do not wish to use
AutoDos, you must remove the tag
from the AutoDos lid before running
the first programme sequence (see
“Detergent – Activating AutoDos”).
You can activate AutoDos.
If you do not wish to use AutoDos, you
can manually dispense the detergent via
the detergent compartment (see
“Detergents - Manual detergent
dispensing”).
 Select the setting you want and
confirm with OK.
This setting applies to all programmes
and you can change it at any time using
the AutoDossensor.
Finally, prompts will appear in the
display.
After confirming these prompts with
OK, the messages Refill salt and
Refill rinse aid may appear.
 Add salt and rinse aid if necessary
(see “Using for the first time -
Dishwasher salt” and “Rinse aid”).
 Select OK to confirm the messages.
When a programme is selected, it will
appear briefly in the display and the
appropriate sensor will be illuminated.
Next, the estimated energy and water
consumption may be shown for the
selected programme for several
seconds.
Then the display will show the
estimated programme running time for
the programme selected.