Miele G 7604 - Display of Programme Duration; Starting a Programme

Operation
77
Display of programme duration
The estimated duration of the selected
programme appears in the display
before the programme begins. During
the programme, the time left until the
end of the programme is displayed.
Each programme stage is indicated by a
symbol:
 Pre-wash/Soak
 Main wash
 Interim rinse
 Final rinse
 Drying
 Finish
The displayed duration may vary for the
same programme. It is influenced by, for
example, the temperature of the
incoming water, the reactivation cycle of
the water softener, the detergent type,
and the amount of dishes and how
soiled they are.
When a programme is selected for the
first time, the display will show the
average programme duration for a cold
water connection.
The programme durations shown in the
“Programme chart” refer to standard
test loads and temperatures.
Each time a programme is run, the
control module calculates the
programme duration depending on the
temperature of the water taken into the
dishwasher and the size of the load.
Starting a programme
 If necessary, confirm the previously
displayed message with OK.
 Touch the Startsensor.
The programme will start.
The Startsensor lights up.
During the programme sequence, you
can use OK to display the name of the
programme that is currently running.
 Risk of scalding due to hot water.
During operation, water in the
dishwasher may be very hot.
Only open the door if absolutely
necessary and exercise extreme
caution when doing so. Before
closing the door again, leave it ajar for
approx. 20 seconds. This will enable
the temperature in the wash cabinet
to settle.